has now started our last week. On Thursday evening, it's time! Due to technical problems we could be just last Thursday at the drawing of the test cubes with it. It was really exciting to see the emergence of the dice with. To try a white plastic has been used that is known from the interior of refrigerators. It had an extra stamp to be built so that the plastic up in the funnel creates smooth to the tool. Finally had a plate of 5 mm M aterialstärke be used so that the funnel is not too thin. Four sides of each cube halves now have to be ausgefr branches, so we have the strong 3cm margins, where we screw the side panels. The Fräsfirma Kunex the company is very congested, but we were assured that at least two cubes are ready to Thursday. We hope to have it tomorrow, can pick up by Wednesday . So we have just enough time the sides, and the LED mount. laminated
(circumcised or not and ausgfräst) dice half shortly after the deep drawing
0 comments:
Post a Comment